Mudder Clock Movement with Short Hands, 4/25 Inch Maximum Dial Thickness, 3/5 Inch Total Shaft Length
Suitable for 1 - 4 mm (1/ 24 - 4/ 25 inch) thickness clock panel.Jump second movement. Good handwork material to make a clock, suitable for repairing and replacing the broken parts of a clock. Hands are made of aluminum. Please do not install them with too much pressure or they will be bent. Read more Please don’t install the brass hex nut too tight. Please check if the second hand has been pressed down hard. How to install ? 1. Place plastic washer over shaft. 2. Insert shaft through hole in clock surface. 3. Insert shaft through clock face( if appropriate). 4. Place dial plate brass washer over shaft. 5. Attach dial fixing brass hex nut. 6. Attach hour hand and press lightly. 7. Attach minute hand. 8. Press second hand in place. Read more Read more
Product Features
- Hand size: total hour hand length: approx. 43 mm (1.7 inches); Total minute hand length: approx. 54 mm (2.1 inches); Total second hand length: approx. 75 mm (2.95 inches)
- Movement size: total shaft length: 15 mm (3/ 5 inch); Thread length: 6.7 mm (7/ 25 inch); Jump second movement, suitable for 1 - 4 mm (1/ 24 - 4/ 25 inch) thickness clock panel
- Wide application: fit for cross-stitch, three-dimensional embroidery, craft clock, frame-less draw clock, and suitable as DIY quartz wall clock replacement movement parts, etc.
- Good DIY clock supply: suitable for repairing, replacing the broken parts of a clock or serving as good handwork material to make a clock by yourself
- Warm notice: there are some clock parts made of aluminum, please do not install them with too much pressure or they will be bent
Tags:cocoon
Title - Default Title