PLAYOCCAR Car Parasitic Drain Tester, Automotive Electrical System Diagnostic Tool for Current Battery Testing
The battery tester can test while the car ECU remains powered on, without worrying about losing ECU data, and is a simple way to diagnose hidden battery consumption.It also allows the use of standard test leads to measure voltage at different locations on the vehicle during emission testing. Two-color Banana Clip The banana clip is distinguished between red and black. Red is the positive electrode & blue is the negative electrode, which is convenient for distinguishing & connecting. Double Fuse Double fuse protection, to ensure that the instrument will not be damaged due to excessive current. With a connecting cover, it is waterproof and dust proof, and will not be lost. Switch Control Equipped with a switch that can be turned off before connecting to increase safety. When the multimeter is connected, it is convenient to control and prevent power surges through the switch. Read more Powerful Alligator Clip Equipped with a large elastic alligator clip. The handle has a non-slip design that is easy to open. Sensitive Spring Clip It is equipped with a spring clip with a special bending, which can be fully attached to the negative of the battery pile and is very sensitive. Pure Copper Core The core made of pure copper is more conductive and sensitive. The surface is made of pvc material, insulated, wear-resistant, waterproof and safe. Read more How to use: 1. Stop and shut down the engine, open the hood, lock the door, and wait for the ECU to enter sleep.2. Use a spring clip to clamp the negative battery pile, and then use an alligator clip to connect negative battery clip.3. Flip the switch to the ON position (closed), insert the 4mm banana plug (red) into the A/10/20A jack of the multimeter, and insert the 4mm banana plug (black) into the COM jack of the multimeter, turn the dial of the multimeter to point A/ 10A/20A gear.4. Use the M10 version of the hand to loosen the battery pile clamp nut, disconnect the battery pole clamp and the battery pile, you can use cardboard or plastic sheet to separate.5. Toggle the switch to the OFF (disconnected) position, and the current value can be interpreted by a multimeter. Show More... Show More... Show More... Show More... Show More... Application Parasitic draw tester tool can perform a leakage test for your vehicle. Suitable for 6-30V vehicle electrical systems, including DC voltage mode, AC voltage mode, resistance mode, and diode mode. Car battery tester is used to test 12V/24V battery, starting and charging systems. Car battery tester supports Battery test, Cranking test, Charging test, Maximum load test. Can easily, quickly and accurately test the 12V and 24V battery performance of cranking ability, cranking load, maximum load and charging system of the car battery.
Product Features
- WHY NEED ITWhen you find that the electrical system of your beloved car is not working properly because of leakage, then parasitic draw tester tool can perform a leakage test for your vehicle.
- POWERFUL FUNCTIONParasitic drain tester can test the standby of the car ECU, normal working current or abnormal working current electronic components while the car ECU is kept powered on, so there no need to worry about repeated testing due to loss ECU data.
- UNIQUE DESIGNUsing a unique U-shaped battery terminal spring clip, it can be connected to the battery terminal without removing the battery terminal cable. One end is a 4mm pure copper banana plug with safety insulation, and the other end is a pure iron clip.
- UPGRADE OPTIMIZATIONThe car drain tester allows using standard test leads to measure the voltage at different positions of the vehicle during the drainage test. In terms of performance, upgrade protection also did, which the fuse is not easy to blow & power consumption is small.
- EFFICIENT AND SAFEFully wrapped high-current battery clips & low-resistance switches are used, durable & efficient. Tester is equipped with a switch that can be turned off before connection to increase safety. The multimeter passed by the switch during the connection process to prevent power surges.
Tags:dingo
Title - Default Title