PrimoChill System Reboot - Cooling Loop Treatment
System Reboot Install: Step One Empty bottle of ReBoot into 1 US Gallon of fresh DI or Distilled water, and shake for 30 seconds. Add mix to cooling loop. Fill loop with treated solution and be sure to remove as many air bubbles as possible. Start loop pump and begin circulating the treated solution. System Reboot Install: Step Two Run treated solution for at least 24 to 48 hours to ensure loop is properly flushed and treated. While using for longer periods of time doesn't have negative effects, ReBoot is not an effective final coolant and should be replaced with coolant before any extended use of computer. System Reboot Install: Step Three Drain System. Inspect drained solution for debris or foreign particles. Dispose of drained solution. Repeat flush if needed. Fill system with fresh DI or distilled water and flush thoroughly to remove ReBoot solution checking for foam. Drain system again. Reboot needs to be flushed from the system until no foam is seen and water runs clear. System Reboot Install: Step Four Fill loop with your choice of coolant and begin water-cooling. Sys Prep System Reboot Rad Clean Rad Clean Kit Liquid Utopia Primo Prep New Build Cleaner ✓ ✓ ✓ ✓ Existing Build Kit ✓ ✓ ✓ ✓ ✓ Additional Hardware Included ✓ Fluid Protectant ✓ ✓ WARNINGS Do not mix with any pre-mixed coolants as it will over saturate the inhibitors.Not responsible for any hardware damage. Use at your own risk.Not compatible with aluminum water cooling components.
Product Features
Tags:cocoon
Title - Default Title